To remove the broil element, remove two screws on the bracket at the back of the oven.
Remove two screws on the upper bracket.
|
To remove the broil element, remove two screws on the bracket at the back of the oven. Remove two screws on the upper bracket. |
 |
Pull the element forward in to the oven to allow you to disconnect the terminals. To replace the element, reconnect the terminals, feed the wires back through the holes and insulation, and replace the 4 screws in the support brackets. |
 |
Unplug the range before continuing. Remove the back cover. (See page 16 of this training manual.) Remove 2 screws from the power cord box and 1 ground screw. Push the box aside. |
 |
Cut the 9 points that hold the bake heater cover in place and remove the cover. It is a good idea to bend the points on the range inward or clip them off to avoid being stuck or cut in the future. |
 |
Push the fiberglass insulation out of the way. Remove 2 screws and bend up the tabs that hold the bracket in place. |
 |
Pull the hidden bake element and mounting bracket out of the range. Replace the bake element, tighten the 2 screws on the bracket, and bend the bracket tabs down. |
 |
Take the bake heater cover, turn it over, and use 2 sheet metal screws to secure it. Bend the points down or clip them off to avoid being stuck or cut in the future. |
Questions? Comments! Concerns? Report an error?
Let us know!
An e-mail should solve the problem.