CONVECTION ELEMENT, FAN BLADE, and FAN MOTOR

Unplug the range and pull it out so you have access from both front and rear. Remove the back cover. Disconnect the wires on the fan motor and on the convection element.

Remove the 3 screws from the fan covers in the oven. Set the cover(s) aside to prevent damage or bending.

Remove the screws from the convection element bracket and retainer and pull the element forward. When removing the fan blade, notice that the nut is a left-hand thread. The fan blade can be replaced from inside the oven without opening the back cover. DO NOT BEND the blade, or the fan will run out of balance, causing noise, vibration, and poor convection performance.

Remove 3 screws and pull the fan motor assembly forward.

EXPLODED VIEW - CONVECTION FAN

WARMING DRAWER ELEMENT

Pull the drawer all the way open. Remove the screws, one on each side, as shown.

Push the glide lever (down on the left, up on the right) and pull the drawer off the runners.

Remove the bottom bracket screw and the 2 screws at the rear bracket. Pull the element forward and disconnect the wires from the terminals.

Replacement of the warming drawer is the opposite of removal. Pull the runners all the way out. Align the runners with the slots on the range. Push the drawer in until the levers click into place. (Approx. 2 inches.) Pull the drawer open to seat the glides into position. If you don’t hear the levers click, or the bearing glides do not feel seated, remove the drawer and repeat these steps.

Questions? Comments! Concerns? Report an error?
Let us know!
An e-mail should solve the problem.